Preparation Of Top Cabinet; Adapting Microwave Blower For Outside Top Exhaust - Haier HM1630 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF
TOP CABINET
You need to drill holes for the top support
screws, a hole large enough for the power
cord to fit through, and a cutout large
enough for the exhaust adaptor.
CABINET TEMPLATE.
on the TOP CABINET TEMPLATE.
Wear safety goggles when drilling holes in the cabinet bottom.
A3. ADAPTING MICROWAVE BLOWER FOR OUTSIDE
TOP EXHAUST
1.
Place the microwave in its upright
position,with the top of the unit facing up.
Remove the screw that holds the blower
plate to the microwave. Remove and
save the screw holding the blower motor
to the microwave.
2.
Carefully pull out the blower unit. The
wires will extend far enough to allow
you to adjust the blower unit.
3.
Roll the blower unit 90° so that fan
blade openings are facing out the top
of the microwave.
CAUTION:
End A
Before Rotation
Blower Plate
Back of
Microwave
Back of
Microwave
After Rotation
Back of
Back of
Microwave
Microwave
English
Blower Moto
Screw
End B
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mw-7777-01

Table des Matières