Installing Or Change The Charcoal Filter - Haier HM1630 Guide De L'utilisateur

3. Insert a self-aligning screw through top
center cabinet hole. Temporarily secure
the oven by turning the screw at least two
full turns after the threads have engaged.
(It will be completely tightened later.) Be
sure to keep power cord tight. Be careful
not to pinch the cord, especially when
mounting flush to bottom of cabinet.
4. Attach the microwave oven to the top cabinet.
5. Insert 2 self-aligning screws through outer
top cabinet holes. Turn two full turns on
each screw.
6. Tighten center screw completely.
7. Tighten the outer two screws to the top of
the microwave oven. (While tightening
screws, hold the microwave oven in place
against the wall and the top cabinet.)
8. Install grease filters. See the Owner's
Manual packed with the microwave.
C5. INSTALLING OR CHANGE THE CHARCOAL FILTER
NOTE: The charcoal filter is factory installed. Follow these steps to replace
a filter or to install a filter after converting a vented model to recirculating
operation.
1. Remove screws on top of grille using a
#1 Phillips screwdriver.
2. Open the door.
3. Remove the grille. Pull the grille straight off.
4. Install the charcoal filter. When properly
installed, the wire mesh of the filter should be
visible from the front.
5. Replace the grille and the screws.
6. Close the door.
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Self-Aligning Screw
Microwave Oven Top
5
6
Insert mesh-side up
English
Equivalent
to Depth
of Cabinet
Recess
Charcoal
Filter
24