Determining Wall Plate Location - Haier HM1630 Guide De L'utilisateur

C. DETERMINING WALL PLATE LOCATION UNDER YOUR
CABINET.
PLATE POSITION—BENEATH FLAT BOTTOM
CABINET
PLATE POSITION—BENEATH RECESSED
BOTTOM CABINET WITH FRONT OVERHANG
Your cabinets may have decorative trim that interferes with the microwave installation.
Remove the decorative trim to install the microwave properly and to make it level.
THE MICROWAVE MUST BE LEVEL. Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no back or side frame, install the
mounting plate down the same distance as the front overhang depth. This will keep
the microwave level.
1. Measure the inside depth of the
2. Draw a horizontal line on the back wall an equal distance below the cabinet
bottom as the inside depth of the front overhang.
3. For this type of installation with front overhang only, align the mounting tabs with
this horizontal line, not touching the cabinet bottom as described in Step D.
Mounting Plate Tabs
Touching the Cabinet Bottom
Mounting Plate with
Tabs Below Cabinet
Bottom the Same
Distance as the Front
Overhang Depth
30ʺ (76.2 cm)
to Cooktop
front overhang.
PLATE POSITION—BENEATH FRAMED RECESSED
CABINET BOTTOM
English
Mounting Plate Tabs
Touching the Back Frame
30ʺ (76.2 cm)
to Cooktop
10