Placement Of The Mounting Plate; Removing The Mounting Plate; Finding The Wall Studs - Haier HM1630 Guide De L'utilisateur

English

1. PLACEMENT OF THE MOUNTING PLATE

A. REMOVING THE MICROWAVE OVEN FROM THE CARTON/

REMOVING THE MOUNTING PLATE

1. Remove the installation instructions, filters,
glass tray and the small hardware bag. Do
not remove the Styrofoam protecting the
front of the oven.
2. Fold back all 4 carton flaps fully against
carton sides. Then carefully roll the oven
and carton over onto the top side. The oven
should be resting in the Styrofoam.
3. Pull the carton up and off the oven.
4. Remove and properly discard plastic bags.
5. Remove the screws from the mounting
plate. This plate will be used as the rear
wall template and for mounting. Reinstall
the screws into the holes where they were
removed.
B. FINDING THE WALL STUDS
1. Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
OR
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
2. After locating the stud(s), find the center by
probing the wall with a small nail to find the
edges of the stud. Then place a mark
halfway between the edges. The center of
any adjacent studs should be 16" (40.6 cm)
or 24" (61 cm) from this mark.
3. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
9
Styrofoam
Mounting
Screws Plate
Wall
Studs
Center
Carton