Programming And Configuration - Fermax cityline MEMOKEY Manuel D'installation Et Utilisation

PROGRAMMING AND CONFIGURATION

Programming Mode allows you to modify the system's different settings and
configuration.
Initially the system is programmed by default with a 4 digit code. As such the user codes
and MASTER code are 4 digits in length. If you require greater security you can change the
length to 5 or 6 digits. See the chapter on: "Establishing the User Code Length"
1) To enter programming mode (having been in
normal mode), enter the Master Code (1480 by
default).
The system emits "3 beeps" to advise we are in
programming mode, and the green led flashes in quick
sequence.
2) To configure each of the functions (in
programming mode) enter the corresponding
function code (for example: "A4" code length).
At this point the system once again emits "3 beeps"
to advise that the setting entered is correct, and the
green led flashes in a slow sequence .
3) Then a new value is entered to be assigned to
the function selected (for example: selecting a
code of 6 digits in length).
To exit Programing mode at any time, press B or allow 20 seconds to elapse without any
activity.
NOTES:
Default Master Code:
- 4 digit length: 1480
- 5 digit length: 14803
- 6 digit length: 148036
If for any reason we need to reset the master code, having forgotten the previous one (refer to the
corresponding chapter: "Restoring Factory Settings"), this will be the master code established for
this operation.
Below are all the system functions and the configuration steps for each of these.
beep (x3) :
1 2 3
4 5 6
7 8 9
0
A B
Enter 1480
beep (x3) :
1 2 3
4 5 6
7 8 9
A 0 B
Enter A4
beep (x3) :
1 2 3
4 5 6
7 8 9
A 0 B
Press 6
Page 5