Configuration And Programming; Codes Menu - Fermax 2532 Manuel D'installation

CONFIGURATION AND PROGRAMMING

Once the installation has been carried out, it will be necessary to define the basic operating
parameters (number of digits, conversation times, language, etc.).
To go to programming mode, you must enter the following sequence using the keypad:
0
The different options of the main menu will appear on the screen:

Codes Menu

1
Codes Menu
Menu Codigos
1- Digitos
1- Digits
2- Cod. Prog.
2- Prog. Code
B- Exit
B- Salir
NOTE: Use the < B> key to validate the changes made and/or to exit the
menu.
Access Code
Codigo de acceso
A B 2 1 A B
Main Menu
Menu principal
1- Codigos
1- Codes
2- Parametros
3- Decoders
2- Parameters
4- MDS City
3- Decoders
5- Display
4- MDS City
5- Display
B- Salir
B- Exit
This makes it possible to modify the number of digits
of the programming codes and change the code used
to enter programming.
1- Digits
You can select the number of digits of the access code
(see above) and the to change the mode code,
between 4, 5 and 6 digits. In the case of 4 or 5, it will
only be necessary to enter the first digits.
2- Programming code
Enter the new code (always 5 digits).
Cod. programacion
Programming Code
1 9 0 2 5
Page 5