Table des Matières
Publicité
ENGLISH
QUICK PROGRAMMING GUIDE
CONFIGURE AS MASTER PANEL
The programming is always done from the
MASTER panel and there can only be one
in the complete installation.
Configuring the master panel: Press the
SW1 button 3 times quickly, it is activated
as a MASTER panel and a confirmation
tone sounds (beep-beep).
PROGRAMMING THE TELEPHONE
1. With the telephone connected, press the programming button (you will hear a beep).
Upon releasing it, you will hear the entrance into programming.
2. Press the call-to-residence button. A programming confirmation is produced.
* The telephone will not function if it has not been programmed.
DEACTIVATE MASTER MODE ON THE PANEL
Once having completed the terminal´s configuration, deactivate the MASTER panel to
avoid accidentally reprogramming terminals.
Deactivating the master panel: Press the SW1 3 times consecutively fast, and it will
deactivate the panel as MASTER. A deactivation tone sounds (beep-bop).
ENCODING PANELS
Whenever there are more than one
panel (to a block) you must program
the panel number, but for this you
need key 7439.
Connecting the keypad:
a) With the power off, remove the skyline button module connected to the CN1 on the
amplifier.
b) Use the 6 way cable to connect the keypad as shown in the diagram.
c) Reconnect the power supply. Now you can program the required parameters with the
keypad.
d) Before completing the keypad disconnection operations and connecting the new skyline
button module, remove the power.
54
KIT AUDIO SKYLINE DUOX PLUS 3-12 L
1
6 way cable
2
Programming
button
< 2,5 min
1
2
4
5
7
8
A
0
ref. 7439
3
6
9
B
Publicité
Table des Matières
