Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
Installation Instructions:
1.)
Remove sill protection from luggage compartment loading sill.
Release right and left side panelling in luggage compartment.
Release securing eyelet at rear left and right.
2.)
Unscrew rear bumper (2).
3.)
Remove screens below taillamps (3).
4.)
Unscrew towing eye (not required) and insert provided plugs into bodywork - see arrow (4).
5.)
Remove existing spacer plates (on bumper screw points).
Fit provided brackets 5 (left and right) on bumper.
To secure brackets 5, fit and tighten nuts.
6.)
Transfer bores 6 (in brackets 5) to bumper carrier.
Unscrew brackets 5, mark bores 6 and drill bores, dia. 6,5 mm (4x), in bumper carrier.
Reinstall brackets 5, insert Toptite bolts M8x25 in bores 6 and tighten.
Tightening torque = 20 Nm
Again remove nut M10.
36
Publicité
Table des Matières
