Installation
Installation
Installing the sounder
Step 1: Select installation location for the sounder
Select an installation location which:
is inaccessible to intruders and vandals.
can be reached with cabling.
Step 2: Open the sounder's cover
Open the cover for the housing screw on the lower side (see Fig. 1).
Remove the screws and open the cover by lifting it upwards.
Step 3: Mount the sounder on the wall
A predetermined breaking point fixed for wall installation by the upper screw serves as
an anti-removal wall contact.
Note
Position the sounder on the wall. Mark the three fixing points.
Drill the holes in the wall to fit the diameter of the screw anchors. Insert the screw anchors
supplied, in the holes.
Feed the cable provided in the inner housing through the cable inlet on the reverse side.
Insert the screws supplied through the sounder's fixing holes. Turn the screws in the
screw anchors. Do not tighten the screws yet.
Align the sounder using a spirit level. Now tighten the screws.
Step 4: Pre-configuration via jumper
On the "SW1" jumper (Fig. 1), there are two options for positioning the jumper:
S1: If the jumper is in contact with the upper two PINs (S1), the following setting is thus selected:
Increasing signal tone. This means that the tone pulsates and produces the standard sounder
signal.
S2: If the jumper is in contact with the lower two PINs (S2), the following setting is thus selected:
Continuous signal tone. This means that the tone builds up once and then maintains its frequency;
it sounds a continuous signal.
8