Technical Data - Hilti DX 5 GR Mode D'emploi Original

3.2 Intended use
The product described is a fastening tool for driving nails, studs and composite fasteners into steel.
When using the tool, always ensure that the correct equipment is used. Fastener guide, piston and fasteners
must be compatible with one another.
3.3 Minimum distances and spacing
3.3.1 Fastening to steel
Always observe the following minimum distances and spacing when fastening to steel:
• The minimum distance from the edge of the working surface to the fastener must be at least 15 mm.
• The minimum center-to-center distance between two fasteners must be at least 20 mm.
• The base material must have a thickness of at least 6 mm.
3.4 Information about the app
To find out more about the app, to download it and start it, scan the QR code in the case.
3.5 Information about the field of applications
Please refer to the Hilti product page for more information about the field of applications.
4

Technical data

4.1 Direct fastening tool
Weight
Tool length
Nail length
Recommended maximum fastening rate
Application temperature (ambient temperature)
Compression stroke
Pressure required
4.2 Vibration
The vibration value that must be specified in accordance with 2006/42/EC does not exceed 2,5 m/s².
5 Operation
5.1 Safety devices
Before commencing work, check that all safety devices are fitted and that they are functioning correctly.
All parts must be fitted correctly and fulfill all conditions necessary for the correct operation of the tool.
5.2 Loading the single-fastener tool
1. Push the fastener into the tool from the front until it is held in place in the tool by the fastener's washer.
2. Push the cartridge strip, narrow end first, into the grip of the tool from below until the full length of the
cartridge strip is inside the tool. If you wish to use a cartridge strip in which some of the cartridges have
already been used, start pulling the strip up and out the top of the tool by hand until the first unused
cartridge is in place in the cartridge chamber.
2147993
*2147993*
Printed: 02.08.2018 | Doc-Nr: PUB / 5292635 / 000 / 02
DX 5 GR
DX 5 GR
DX 5 GR
DX 5 GR
2
DX 5 GR
8.49 lb
(3.85 kg)
19.8 in
(503 mm)
≤ 0.9 in
(≤ 22 mm)
700 rev/h
5 ℉ ... 122 ℉
(−15 ℃ ... 50 ℃)
1.3 in
(32 mm)
≥ 11 lb
f
(≥ 50 N)
English 5