Installation; Minimum Clearances To Hard Surfaces; Installing The Wall Mounting Bracket; Heater Installation - Stiebel Eltron CON 100-1 Premium Utilisation Et Installation

INSTALLATION

Installation
11. Installation

11.1 Minimum clearances to hard surfaces

ANY HARD SURFACE
FLOOR

11.2 Installing the wall mounting bracket

The heater is intended for wall mounting using the supplied wall
mounting bracket. The heater may only be installed horizontally.
Note
- The wall mounting bracket can be used as a tem-
plate for wall mounting. This ensures sufficient
clearance from the floor.
- Use a level if the floor is uneven or sloping.
1 2
a a a
Unhook the wall mounting bracket from the heater.
Place the centred wall mounting bracket horizontally on the
floor. Mark holes 1 and 2.
10 | CON Premium

11.3 Heater installation

1 Wall mounting bracket
3 4
1 Heater
2 Captive locking screws (attached)
3 Secure the heater against unintentional release, using the

11.4 Dismounting the heater

Lift up the wall mounting bracket so that its lower holes
match up with the markings you have just made on the in-
stallation wall.
Mark holes 3 and 4 on the installation wall.
Drill the holes at the 4 markings.
Secure the wall mounting bracket with suitable fixing mate-
rials (screws, wall anchors). With the vertical slots, you can
compensate for an offset mounting hole.
Hook the heater onto the bottom tabs of the wall mounting
bracket by the slots in the back of the heater.
Place the heater in an upright position.
Secure the heater by pushing it towards the wall until it au-
dibly snaps into place in the two upper springs on the wall
mounting bracket.
1
supplied captive locking screws on the left- and right-hand
sides of the wall mounting bracket.
Loosen the captive locking screws attached to the wall
mounting bracket.
To release the heater, push down the springs at the top of the
wall mounting bracket.
Tilt the heater away from the wall and lift it off the bottom
tabs of the wall mounting bracket.
www.stiebel-eltron-usa.com
1
2