Unpacking; Preparing For Use; Operation; Filling And Mounting The Mixer Jug - SilverCrest SSM 550 D1 Mode D'emploi

Unpacking

• Remove all packaging materials or protective fo-
ils from the appliance. Retain the packaging, so
that you can store the appliance with protection
or send it by post, e.g. should it need repair.
• Before taking the appliance into use, check to
ensure that it is free of damage, check also that
the power cable and plug as well as all accesso-
ries and appliance parts are undamaged.
• Carefully clean all components before
taking the appliance into use for the first time
(see "Cleaning").

Preparing for use

When all components have been cleaned as described
under "Cleaning":
➩
Position the appliance such that, ...
– that the power cable
cess at the rear of the appliance,
– the power plug is immediately accessible, so that
it can be quickly withdrawn in the event of danger,
– that it is stable and not liable to slip, and such
that the suction cups find a firm hold so that the
appliance cannot tip over due to vibration,
– that the power cable
area and thus not presenting a risk of being inad-
vertently snagged and tipping the appliance
over.
passes through the re-
y
is not in the working
y

Operation

Warning!
The motor switches itself off as soon as the mixer
jug e is removed from the motor block
then be overlooked that the appliance is still swit-
ched on. The motor will thus start of its own accord
as soon as the mixer jug
Therefore:
• First insert the power plug into the wall socket
when the mixer jug
its lid fitted and closed.
• Before mounting the mixing jug always check to
see that the appliance is switched off or that the
power plug has been removed.
• Before removing the mixer jug
pliance off, remove the power plug and wait for
the motor to stop revolving.

Filling and mounting the mixer jug

➩
Take the mixer jug
and remove the cover
➩
Fill the mixer jug
firmly back onto the mixer jug
pourer nose on the mixer jug
➩
Insert the filling cap
secure it by turning it clockwise.
Note
Ensure that the switch
before fitting the mixer jug
. Otherwise the appliance will start automatically
u
as soon as the mixer jug
➩
Place the ready filled and sealed mixer jug
onto the motor block
jug until you can press it down. The motor
e
can start only when the mixer jug
positioned.
- 29 -
u
e is replaced on it:
e is filled and mounted with
, switch the ap-
e
from the motor block
e
.
w
and then press the cover
e
. Ensure that the
e
is also closed.
e
into the lid opening and
q
t is set to the "OFF" position
onto the motor unit
e
e sits flush on the unit.
u . Lightly turn the mixer
is securely
e
. It could
u
w
e