Cleaning Program - Melitta Latticia OT Mode D'emploi

Care and maintenance
4. Reassemble the milk unit properly.
Make sure that you push the milk unit
upwards to the end stop when assem-
bling it.

7.5 Cleaning program

This cleaning program is used to remove
residues and coffee oil residues. You should
run the program every two months or
when the appliance asks you to do so.
Only use Melitta® Perfect Clean cleaning
tabs for automatic coffeemakers. Observe
the instructions on the packaging of the
cleaning tabs.
Caution! Cleaning agent causes eye
irritation. If it accidentally comes into
contact with your eyes, you should
rinse them with clear water for several
minutes. Consult a doctor if symptoms
persist.
The program takes approximately 15 min-
utes and should not be interrupted. The
program runs in several stages. Progress is
indicated by the number of coffee beans
displayed.
The Clean display light tells you to
clean the appliance.
1. Fill the water tank with tap water up
to the maximum filling level. Insert the
water tank.
2. Press the "Water/Service" button
for longer than 2 seconds to access
Service mode 1.
3. Press the "Water/Service"
button repeatedly until the Cleaning
display lights up.
4. Press the "Water/Service" button
for longer than 2 seconds.
» The cleaning program starts.
The Cleaning display flashes for the
duration of the program.
» The Drip tray display lights up.
5. Empty the drip tray and the coffee
grounds container.
6. Insert the drip tray without the coffee
grounds container and place the coffee
grounds container under the outlet.
The first stage starts.
28
» The appliance rinses twice.
» The Cleaning display flashes
rapidly.
7. Remove the brewing unit. Do not
switch off the appliance.
8. Rinse the brewing unit under running
water (see section 7.2, page 26).
9. Place a cleaning tab in the brewing
unit. Insert the brewing unit into the
appliance.
The second stage starts.
» The appliance performs several rins-
ing operations.
» The Drip tray display lights up.
The third stage starts .
10. Empty the drip tray and the coffee
grounds container.
11. Insert the drip tray without the coffee
grounds container and place the coffee
grounds container under the outlet.
The fourth stage starts. The three
coffee beans flash.
» The appliance performs several rins-
ing operations.
» The Drip tray display lights up.
12. Empty the drip tray and the coffee
grounds container.
13. Insert the drip tray with the coffee
grounds container.
» The appliance is ready for operation.
If the cleaning program has been inter-
rupted, e.g. because you unintentionally
switched off the appliance, you must
switch the appliance on again and follow
the instructions from step 10. The appli-
ance is then ready for operation, even if it
has not been completely cleaned. For com-
plete cleaning, you must start the cleaning
program again.