Vermeiren Pratic HC Mode D'emploi page 20

3.3.2 Slatted Frame
Insert head end using the c-profile on the bearing receiving means for the
1.
undercarriage.
Insert the feet end using the connection pipe to the head end. Connect the feet end to
2.
the undercarriage using locking pins.
Carefully fasten the screws in the connection pipes to the mattress slatted frame.
3.
3.3.3 Head panel / feet panel
L
CAUTION:
Risk of clamping - Make sure that the motor cables cannot be
crushed.
Insert the front ends (2) in the open pipe ends on the mattress slatted frame (1), both on
1.
the head end and the feet end until they click (the locking screws (3) need to be
loosened first). Carefully tighten all the locking screws (3) to the mattress slatted frame.
2
3

Fasten all components with the locking screws. While doing so, the locking screws
need to be tight enough to guarantee that the front section is securely fastened.
3.3.4 Transformer connections
L
CAUTION:
Risk of injury - Do not touch the plug with wet hands.
L
CAUTION:
Risk of injury - Do not place any objects on the connection and the
cable, and protect these against mechanical loads.
1. A 220 V / 230 V, 50 Hz power socket conforming to the VDE specifications is required
2. The diagram for the transformer connections is given in the figure below:
1
Page 18
Pratic HC
2014-06
1 = Mattress slatted
frame
2 = Inserts panels
3 = Locking screws
3