Potential Equalization; Rastomat; Operating The Steering Casters - Vermeiren Pratic HC Mode D'emploi

Following adjustments can be used:
2.2

Potential equalization

A potential connection is located under the mattress frame. This connection is used to switch
conducting components to the same potential, should electrical components be used as part
of the bed. Connect the potential equalization to the outgoing independent grid. Follow the
instructions for the additional electrical components.
l
Make sure that the cable connections are fastened tightly.
2.3

Rastomat

L
CAUTION: Risk of injury -
adjusting is being done.
To adjust the lying surface for the lower leg, grip the foot-end toggle strap in the middle of the
frame. Pull the lying surface for the lower leg to the desired height. The Rastomat will click
into the notch locks at intervals of approx. 2cm. To lower the surface for the lower leg, use
the foot-end toggle strap and pull it to the upper position. The Rastomat will then remove the
lock. You can now completely lower the leg surface slowly until it rests on the bed frame.
Only make adjustments when the grips are at the foot of the bed. Otherwise the bed can tip
over and the adjustment mechanism damaged.
2.4

Operating the steering casters

L
WARNING:
Good operation of the steering casters is influenced by wear and
contamination of the tires (water, oil, ...) – Check the condition of the castors
before each use.
Back section down and up function
Mattress support platform down and up
Leg down and up function
Potential equalization connection
No people or objects allowed close to where
Page 8
Pratic HC
2014-06