Transfer In And Out The Bed; Transport - Vermeiren Pratic HC Mode D'emploi


Insert the boom (1) as far as it will go into the relevant socket (2).

Let the arresting bolts (3) slide into the groove (4).

Pull the metal loop over the end of the upper frame (5) until the bolts engage one of
the three socket holes (6).

Also pull strap (7) into the metal loop and through the triangle (8); then fix its length.
Secure the strap.

2.10 Transfer in and out the bed

L
CAUTION:
Risk of falling
manner, ask someone to assist you.
1. Position you as close as possible to the bed.
2. Check the brakes from the bed are in the on position.
3. Remove or fold down the side railings of the bed.
4. Transfer to/from the bed.

2.11 Transport

L
WARNING:
Risk of injury – Make sure that the bed is attached properly in the car
or truck.
L
WARNING:
Risk of injury – Transportation of the bed shall be only without the
patient.
To avoid damage when transported, the lifting pole should be detached. Unplug the power
cable and check that no cables hang near the floor.
Should the bed be transported over greater distances, use the transport set to do so.
Installing the transport set:

Lower the bed into its lowest position and then remove the power cable from the
power supply.

Insert the transport kit (1) in the mattress frame (2) (headside). Fasten the transport
kit with the star bolts (3).

Then turn the mattress frame on the side where the transport kit is mounted thus
moving the transport set's castors downward. The bed can now be pushed easily on
the rolling castors.
-
In case you cannot perform the transfer in a safe
Page 13
Pratic HC
2014-06