VOLTCRAFT B6 Ultimate Notice D'emploi page 72

You can stop the warning signal by pressing the "TYPE/STOP" button. You then return
to the previous configuration menu.
If you do not, the following display appears (alternating):
R: 3SER R: 3SER
R: 3SER R: 3SER R: 3SER
CONFIRM(ENTER) CONFIRM(ENTER) CONFIRM(ENTER)
CONFIRM(ENTER) CONFIRM(ENTER)
The "R" value indicates the number of cells detected by the charger.
The "S" value indicates the number of cells set in the menu.
If these two numbers do not match, please check the settings on the charger
and the battery itself. It may be that the LiPo battery has been completely
discharged, or a cell may be faulty. In this case, the battery should not be
charged, as there is a risk of fire and explosion!
You can return to the previous configuration menu using the "TYPE/STOP"
button.
• If the two numbers match, you can start the charging process by shortly pressing the
"ENTER/START" button.
• Once the charging process has been started, various pieces of information about the
current charging progress are shown on the display - see next image:
Example:
Number of cells
Li3S 1.2A 12.59V Li3S 1.2A 12.59V
Li3S 1.2A 12.59V
Li3S 1.2A 12.59V Li3S 1.2A 12.59V
CHG 022:43 00682 CHG 022:43 00682
CHG 022:43 00682 CHG 022:43 00682 CHG 022:43 00682
Current charging duration
• Once the charging process has been completed, an audio signal is emitted (if it was not
turned off).
If you wish to terminate the charging process beforehand, press the "TYPE/STOP"
button.
72
S: 3SER S: 3SER
S: 3SER S: 3SER S: 3SER
Charge current
R: 3SER R: 3SER
R: 3SER R: 3SER R: 3SER
CANCEL(STOP) CANCEL(STOP) CANCEL(STOP)
CANCEL(STOP) CANCEL(STOP)
Battery voltage
Charge capacity in mAh
S: 3SER S: 3SER
S: 3SER S: 3SER S: 3SER