Using The Automatic Warm-Up Function; Do Not Use The Automatic Warm-Up Function - AEG ELECTROLUX EHS 8680 X Notice D'utilisation Et Instructions D'installation

Using the automatic warm-up
function
Switching on the automatic warm-up
function
The duration of the warm-up phase depends on
the heat setting selected.
Set the required heat setting (
"heat setting selection" sensor field
The set power level lights up in the digital display.
lights up in the digital display after approx. five
seconds.
The automatic warm-up function is activated.
In the event of residual heat being
present the automatic warm-up function
will not be activated for this cooking
zone.
After the end of the warm-up time, the heat setting
selected will be shown again.
When the automatic warm-up function is
active select a higher heat setting, e.g.
instead of
be automatically adjusted to the selected
heat setting.
If you select a lower heat setting the
automatic warm-up function will be
switched off immediately.
Switching off the automatic warm-up
function
Only an activated automatic warm-up function may
be switched off.
Touch the „heat setting selection"
The heat setting selected lights up in the digital
display.
The automatic warm-up function is switched off.
Do not use the automatic warm-up
function
The cooking zone is used without the automatic
warm-up function if the required heat level is set
via the „heat setting selection"
to ) via the
.
, the warm-up time will
sensor field.
sensor field.
18