Table des Matières
Publicité
2. Strictly comply with these instructions
to avoid serious risks or hazards.
9.1 STORING
When the machine is to be stored away:
1. Disconnect the machine from
the battery backpack;
2. Remove the battery from its
compartment and recharge it;
3. Apply the guard to the blade;
4. Wait until the engine has
properly cooled down;
5. Clean (para. 7.3);
6. make sure there are no loose
or damaged components;
7. if necessary, replace the damaged
components and tighten any
screws and loose bolts or contact
the authorised service centre.
8. Store the machine:
• in a dry place;
• protected from inclement weather;
• in a place out of children's reach;
• making sure that keys or tools used
for maintenance are removed.
9.2 STORING THE BATTERY
The battery must be kept in a cool,
shaded place without humidity.
NOTE
In case of prolonged inactivity,
recharge the battery every two months
to prolong its service life.
10. HANDLING AND TRANSPORT
Whenever the machine is to be handled,
lifted, transported or tilted you must:
1. stop the machine;
2. Wait until the cutting means stops;
3. Disconnect the machine from
the battery backpack;
4. Remove the battery from its
compartment and recharge it;
5. Apply the guard to the blade;
6. Wait until the engine has
properly cooled down;
7. wear protective work gloves;
8. Only hold the machine using the hand
grips and position the bar in the opposite
direction to that used during operations.
When transporting the machine
on a vehicle, always:
• Properly secure the machine;
• position it so that it does not
cause a hazard to anyone.
11. ASSISTANCE AND REPAIRS
This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only Authorised Service Centres can carry
out guaranteed repairs and maintenance.
• The Authorised Service Centres only
use genuine spare parts. Genuine
spare parts and attachments have been
designed specifically for machines.
• Non-genuine spare parts and accessories
are not approved. Use of non-genuine
spare parts and accessories cause
the warranty to be voided.
• It is advisable to send your machine
once a year to an Authorised Service
Centre for servicing, assistance
and safety device inspection.
12. WARRANTY COVERAGE
The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover damage caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of attachments not supplied or
not approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables such
as wheels, blades, safety bolts and wires.
• Normal wear and tear.
EN - 13
Publicité
Table des Matières
