Getting Started; Connecting Headphones; Quick Start - Minelab SDC 2300 Manuel D'instruction

6

Getting Started

Connecting Headphones

The detector may be used with the built-in
speaker or the headphones supplied.
To attach the headphones, remove the
dust caps from the headphone plug and
headphone socket. Hold the headphone by
the rubber collar using thumb and index
finger, the raised double arrow should
be uppermost. Align the plug with the
headphone socket and squeezing firmly, slide
the collar onto the socket.
The detector's built-in speaker will be
automatically muted when headphones are
connected.
DO NOT submerge the
headphones!
The headphone earpieces are NOT
waterproof. Only the headphone
cable and connector is waterproof.
If submerging the unit beyond wading depth,
the headphones must be removed and the LED
indicators used to indicate a detection.

Quick Start

The following steps are a good general
procedure to get you detecting quickly.
1. Ensure detector is set to Normal mode 2
(green).
2. Turn on (see 'Turning the Detector On')
3. Perform Noise Cancel (if required) (page
8)
4. Set Threshold (if required) (page 8)
5. Perform Fast Ground Balance (page 9)
6. Start detecting
NOTE: Settings may need to be further
adjusted depending on individual ground
conditions.
Turning the Detector On
Before you turn the detector on, hold the coil
away from any metallic objects.
To turn on the detector, lift and rotate the
power switch clockwise, then release.
The SDC 2300 will emit a series of four or five
rising tones and then the LEDs will illuminate.
The detector is ready to use.