Minelab SDC 2300 Manuel D'instruction page 6

4 Setting Up
Continued...
7. Adjust coil angle
Adjust the angle of the coil so that it is parallel
to the ground when the detector is held in the
operational position.
Packing Up
To pack up the detector and return it to its
compact state, perform the following steps:
1. Retract the armrest wings and the armrest.
2. Hold the bottom of the detector with one
hand, and use base of the palm of the
other hand to firmly impact the top of the
handle behind the LED display. This will
collapse the handle assembly.
BE CAREFUL!
Keep your fingers clear of
the handle and armrest area
when collapsing the handle
assembly.
3. Retract the shafts using the cam-locks
and rotate the shaft and coil back into the
compact position.