Explanation Of Buttons; Operation - Tunturi Cardio Fit R60w Manuel De L'utilisateur

Strokes
- Without setting the target value, strokes will
count up.
- When setting the target value, strokes will
count down from your target distance to 0 with
an alarm sound or flash. (During countdown
"Remaining" is shown )
- Range 0 ~9990 /± 10
Total Strokes
will display the total strokes of all workouts.
This value cannot be reset, other than by
changing the batteries.
SPM
- SPM is Strokes Per Minute and is showing the
avarage Strokes per minute during workout.
- In "Training Mode" this can be set as target in
range 20~80.
- A+SPM: When workout is stopped, it will
display average SPM value of latest workout.
Standby mode
In standby mode the console will display:
- Real time
- Real date
- Environment temperature (°Celsius)
To set correct time/ date settings,
- Press and hold Reset button for 3 seconds to
enter time/ date programming mode.
- Use Up/ Down keys to adjust Time/ Date
parameters and Enter to confirm settings.
Alarm function
After setting time/ date parameters right, you can
also choose to set an Alarm.
(Alarm can only sound in standby mode.)
- Set Alarm in on or off mode by using up/ down
keys, and confirm with enter.
- If Alarm is in on mode ( Bell is shown) the Hour
digits will blink, set required alarm hour time by
using up / down keys and confirm with enter.
- Do the same for minutes, and confirm with
enter.
- Your alarm is set, and will be activated ( only if
console is in standby mode)
(HH:MM)
(YYYY/ MM/ DD)

Explanation of buttons

Up
- Setting selection.
- Increase the value.
Down
- Setting selection.
- Decrease the value.
Enter
- Confirm setting. (in programming mode)
- Scan parameters (in workout mode)
Start/ Stop
- Start workout. (in programming mode)
- Stop ( Pause) workout.
- Resume training. (in stop mode)
Reset
- In setting mode, press RESET key once to reset
the current function figures.
- Press RESET key and hold for 2 seconds to reset
all function figures, and reboot console.
Recovery
- The RECOVERY key will only be valid if pulse is
detected.
- TIME will show „0:60" (seconds) and counts
down to 0.
- Computer will show F1 to F6 after the
countdown to test heart rate recovery status.
User can find the heart rate recovery level
based on the chart below.
- Press RECOVERY key again to return to the
beginning.
F1 Outstanding
F2 Excellent
F3 Good
F4 Fair
F5 Below average
F6 Poor

Operation

Power on
- Press any key to power on the console when
being in sleep mode..
- Start workout to power on the console when
being in sleep mode.
English
(in workout mode)
19