Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Please read this instruction manual carefully before use.
Introduction
Thank you for choosing this Shredder from Swingline. We are sure it will serve
you well, but please take a little time to read these instructions to ensure you
get the best out of your machine.
Safety First
1.
Please store this instruction manual in a safe place for future reference.
2.
Please pay close attention to the safety symbols on the top of the
shredder and operate the machine accordingly.
3.
If the shredder needs cleaning, unplug the unit from the power socket
and use a damp cloth.
NOTE: Do not use any cleaning products to clean the unit.
4.
Do not position the unit near to an object that radiates heat.
5.
Do not place the unit in a damp environment.
6.
Take care not to splash any liquid onto the machine.
7.
Return the product and proof of purchase with receipt to the store at
which it was purchased if...
- The power cable or plug is broken.
- The machine malfunctions because liquid was accidentally spilt onto
the machine.
- The shredder doesn't operate despite following the guidelines in the
manual.
8.
Make sure the power cable isn't a trip hazard.
9.
Please ensure the power supply is compatible with the requirements of
the machine (120Vac~60Hz).
10. To avoid risk of injury, do not open the machine's casing to attempt DIY
repair. Any attempted repair by an unqualified person will invalidate the
warranty.
Description of product parts (fig 1)
A
Power cable
B
Viewing window
C
Paper entry slot
Preparation before use
How to use the shredder correctly:
1.
Take care not to insert fingers, ties or other objects into the entry slot of
the shredder.
2.
Try to avoid paper clips, staples, laminating materials, plastic bags etc.
from being passed through the shredder. This will prevent damage to the
cutters.
3.
Do not shred wet paper as it can tangle in the cutters.
4.
Do not shred more than the stated sheet capacity in one pass.
5.
Do not shred continuously for more than 3 minutes at a time. Running
the unit for too long may make the motor overheat. If the motor over
heats, allow it to cool down for at least 30 minutes before resuming use.
6.
Do not use the "REV" (
use of the "REV" (
) function can result in shredded paper becoming
jammed in the entry slot, which will adversely affect the performance of
the shredder.
4
) (reverse) function if it's not necessary. Over
Correct operating procedure (fig 2)
1.
Insert plug into the AC power socket.
2.
Check the shredder bin is fully closed.
3.
Push the switch to the ON/AUTO position (standby mode)
4.
When not in use, push the switch to the O (off position)
Auto shred and stop
-
Place the paper or credit card into the centre of the entry slot - shredding
will start automatically (fig 3).
-
Paper smaller than A4 in width should be placed in the middle of the entry
slot to ensure the shredder works automatically.
-
The cutters will stop rotating automatically after finishing shredding
-
Do not shred more than the stated sheet capacity at a time.
-
If too many sheets are inserted at a time, the shredder can become
jammed. If the shredder becomes jammed, switch the button to REV
(
) position to clear the jam by reversing the paper. If the paper has
become so entangled in the cutter that it can't be reversed, turn off the
power and pull out the paper by hand. Restart with fewer sheets and feed
the non-shredded end of the paper in first.
Register this product online at www.swingline.com
Publicité
Table des Matières
