Safety First; Description Of Product Parts - Swingline Stack-and-Shred 60X Manuel D'utilisation

Specifications
Sheet capacity
Manual feed slot
Sheet capacity
Autofeed chamber
Duty cycle
Run time from cold
Volts / Hz
Amperage
Motor watts
Introduction
Thank you for choosing this shredder from Swingline.
Please review these instructions to ensure you are operating
the shredder correctly.

Safety First

To guard against injury, the following basic safety precautions
must be observed in the set-up of this product.
• Ensure the machine is plugged into an easily accessible power
outlet, and ensure the cable is not likely to trip up a passer by.
• Any attempt to repair this unit by unqualified personnel will
invalidate the warranty. Please return to supplier.
• Unplug your shredder before moving it or when it is not in use
for an extended period of time.
• Do NOT operate with a damaged power supply cord or plug,
after it malfunctions, or after it has been damaged in any
manner.
• Do NOT overload electrical outlets beyond capacity as this can
result in fire or electrical shock.
• The socket-outlet should be installed near the equipment and
shall be easily accessible.
• Do NOT alter the attachment plug. The plug is configured for
the appropriate electrical supply.
• Do NOT use near water.
• Do NOT use aerosol dusters or cleaners.
• Do NOT spray anything into the shredder.
• Do NOT load the auto-feed chamber with unopened junk mail,
magazines, bound documents etc.
Although this shredder has been designed to comply with UL
60950 safety standards including the "probe accessibility tests",
do not operate the shredder near children or pets.
Swingline Stack and Shred 60X
5 sheets (75gsm)
60 sheets (75gsm)
6 min ON / 40 min OFF
8 minutes
120V / 60Hz
1.2 Amps
140 Watts

Description of product parts

U ON/OFF switch (at rear of machine)
A
U Important safety symbols
B
(see shredder control panel below)
U Manual feed entry slot
C
U Credit card slot
D
U Reverse, auto, continuous jam boost switch (FWD)
E
U Paper loading door handle
F
U Paper loading door
G
U Power on indicator
H
U Cool down indicator
I
U Pull out bin with viewing window
J
Shredder Control Panel
and Indicators
Reverse
Power On indicator – This means the machine is
turned on.
Cool Down indicator – This means the machine is
cooling down.
Safety First
This means you should be careful because long hair
can become entangled in the cutting head.
This means be careful of ties and other loose clothing
which could become entangled in the cutting head.
This means be careful of loose jewelry which could
become entangeld in the cutting head.
This means don't reach into the feed opening of the
cutting head.
This means keep children away from shredder.
This means no aerosols.
This means the shredder can't shred CDs or DVDs.
This means no oil lubricant (oil sheets only).
Sheet capacity of manual feed entry slot.
This means the shredder can accept small staples.
This means the shredder can accept small paperclips.
This means the shredder can accept credit cards.
Continuous
Auto
Jam Boost
4