Intended Use; Lighting The Burners - Franke FHCL 604 3G TC Manuel D'installation Et Mode D'emploi

FHCL 604 3G TC / FHCL 755 4G TC / FHTL 604 3G TC / FHTL 604 4G / FHTL 755 4G TC
Accessing the hob
To access the tray containing the functional
parts, proceed as follows:
– Remove the grids, burner caps and flame-
spreaders;
– Remove the knobs, sliding them off their
pins;
– Remove the screws that fix the burners to
the hob;
– Lift the hob.

INTENDED USE

CAUTION: This appliance is for cooking
purposes only. It must not be used for other
purposes, for example room heating.
Do not pull the appliance or the power
cable to unplug it.
Close the general gas supply cock when
the hob is not in use.
Risk of burns!
Do not touch the pot grids during use.
Do not touch the appliance with wet parts
of the body.

Lighting the burners

The hob is lit with the control knobs. To light
the burners, proceed as follows:
– Press and turn the required knob to the
lighting and max delivery position.
– Keep the knob pressed down for 3-4
seconds to allow the sparks to ignite the
gas coming out the burner and to allow the
thermocouple to heat up.
– Then release the knob and, turning
it anticlockwise, adjust the flame as
required. If the flame does not stay lit,
repeat the operation from step 1.
IMPORTANT: When converting the appliance to
a different type of gas, place the corresponding
sticker (supplied as an accessory) in the
special space on the data plate. For operation
with LPG (G30 or G31), the minimum flame
adjustment screw must be fully screwed down.
These appliances are supplied in cat. II 2H3+.
Knob
Function
icon
Off
Minimum
flame
Lighting and
maximum
flame
Cooking zone
The hob is an item for daily use: signs of usage
such as scratches or visible material abrasion
from pots or cookware are normal. Intensive
use leads to more distinctive signs of usage.
In such cases, the appliance continues to
function perfectly and a complaint is not
justified. Safety is always guaranteed.
– 11 –
EN