Ivoclar Vivadent Bluephase G4 Mode D'emploi page 12

Click & Cure corded operation
(only in charging base with integrated radiometer)
If a charging base with an integrated radiometer is
used, Bluephase G4 can be used in corded operation
at any time, but particularly when the battery is
completely empty.
For corded operation, release the battery by pressing on
the release button on the lower part of the handpiece
and then pull the battery out of the handpiece
completely.
Then remove the power pack from the underside of the
charging base. Do not pull on the power cord.
12
Insert the connection plug straight into the handpiece
until you hear and feel it click into place.
During corded operation, the charging base cannot
charge the battery, since it is not connected to a power
source.
A complete disconnection from the power supply is
only ensured when the power cord is disconnected from
the power socket.
Measuring the light intensity
(only in charging base with integrated radiometer)
The integrated radiometer allows the light intensity
(mW/cm ) to be measured easily and quickly while the
2
charging base is connected.
To measure the light intensity, place the tip of the light
guide, without protective cover, flush into the marked
recess on the upper side of the charging base. Then
activate the light and read the value displayed on the
screen. If the light intensity is below 400 mW/cm
screen will display "LOW".
2 , the