Table des Matières
Publicité
2 General Instructions
This instruction manual is being released by
BERNAL without any warranty.
BERNAL reserves the right to make some
changes or modifications on the devices and
on
this
manual
communication before.
2.1 General safety instructions
Important Safety orders:
ATTENTION
FOR THE SAFETY AND LIFE OF
PERSONS IT IS ABSOLUTELY
NECESSARY TO FOLLOW ALL
INSTRUCTIONS.
KEEP THESE INSTRUCTIONS
The mounting of the garage door
opener should only be performed
by
qualified
mounting may lead to serious injuries !
Before any operations on the device pull
out power plug (besides test and learning
procedures) !
While mounting the demanded
regulations
safety
/
insurance association have to be followed,
e.g. UVV, DIN EN 60335-1 and VBG4.
The practical electro installation
has to be performed by an electro
specialist, and has to fit to the
relevant protection norms according to DIN
VDE
0100
and
DIN
protection power outlet has to be accessed
easily and must be distanced max. 50cm
away of the opener head.
The initial operation of the door
arrangement, in which this door
opener
should
permitted until it is detected, that the door
arrangement
is
in
instructions of the norm 98&37&EG and a valid
EC-Declaration of Conformity is certificated.
The manufacturer does not take on any
warranty or product liability, when there has
been an improper installation or if there was
made a change on the opener without his
previous approval. The installation must be
performed
according
without
making
any
personnel.
Wrong
for
the
operational
employers
mutual
VDE
0113.
The
be
mounted,
accordance
with
the
to
the
mounting
directives. The installation of foreign parts
endangers the security of the opener and is
permitted.
You have to pay attention, that the national
VDE-regulations are regarded for operating.
We do not take on any responsibility for the
improper operating or maintenance of the
door, accessories and the opener.
2.2 Intended application
The garage door opener is only arranged for
the operation with well-balanced swing- and
sectional doors in the non-commercial sector.
The recommended max. door measurements
are listed under 1. Technical Data. The door
has to be in accordance with the valid
specifications (e.g. DIN EN 12604 and DIN EN
12605). Before mounting the opener the door
has to be moved easily by hand.
The opener is designed for the operation in dry
rooms.
The garage ceiling has to be constructed so
that a safe attachment of the opener is
possible.
2.3 Advices for operating
For garages without a second entrance a
locking-set is necessary. The locking/set
has
to
be
efficiency!
Do not hang on the rope of the locking-set with
your weight!
Pay attention, that the locking-set of the
opener does not collide with the roof rack or
protrusions of the vehicle or the door.
Inform all persons, who are using the door
arrangement about a safe and proper
handling.
reversion (with a 50 mm high obstacle at
is
max. 150 N) as well as the mechanical
locking.
Operate the door only, when you can watch
over the whole door area. Pay attention,
that there are no persons or subjects in the
area of operating of the door.
- 4 -
checked
monthly
Demonstrate
and
on
its
test
the
Publicité
Table des Matières
