Functional Description; Compressed-Air Supply And Commissioning; Compressed-Air Processing; Ias 3 Hose Connector - Festool LRS 93 M Guide D'utilisation

Compressed air orbital sander
Weight
Accessories shown or described are sometimes not
included in the scope of delivery.
[3-1] On/Off switch
[3-2] Speed control
CAUTION
Risk of injury

Make sure that the pneumatic tool is switched
off when you connect the compressed-air sup-
ply.

Compressed-air processing

The Festool service unit should always be used to
ensure that Festool pneumatic tools function cor-
rectly. Consisting of a filter, control unit, condensa-
tion drain and lubricator, the service unit cleans and
lubricates the compressed air and keeps it free of
condensation. Here, the lubricator should be set so
that a drop is applied to the compressed air approx.
every 7-10 minutes.
Damage that occurs as a result of incorrect com-
pressed-air processing is excluded from warranty
claims.
 We recommend a service unit with a 3/8" con-
nector, when up to two Festool pneumatic tools
are used.
A compressor that supplies at 500 l/min and at an
operating pressure of 87 psi (6 bar) should be used
to supply compressed-air.
The diameter of the piping system must be suffi-
ciently large (at least 3/8" (9 mm)).

IAS 3 hose connector

The sander is a pneumatic tool for connection to the
Festool IAS 3 system. This hose system combines
three functions in one hose:
• Compressed-air supply [1-1]
8

Functional description

Compressed-air supply and commissioning

[4-1] Locking lever
[4-2] Release lever
• Exhaust air extraction [1-2]
• Dust extraction [1-3]
Connection and disconnection - see Fig. [2].
1-1
1-2
1-3
1
2
LRS 93 M
3.1 lbs (1.4 kg)