MRA 4025066168767 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
6 Plastic discs 12x5x0.5mm
2 O-rings, 4.5x1.5mm
2 Distance sleeves 6mm
4 Fillister head screws, M5x20mm
2 Fillister head screws, M5x25mm
1 Edge protection strip with clamping
sleeves
Fitting the windscreen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Disassemble the original fairing screen.
3. Take the MRA windscreen and insert the 5X25mm fillister head screws [10641] with the
plastic washers [10635] through the upper holes of the screen. Now, place the 6mm
distance pieces [11038] against these from behind and secure them with the O-rings
supplied [10992], (P1).
4. Fasten the screen to the motorcycle with the fillister head screws M5x25mm [10641] and
the plastic washers [10635] and additionally to the lower four holes with the fillister head
screws M5x20 [10673] and the plastic washers [10635].
5. Mount the edge protection strip as shown in picture 1. Push the clamping sleeves over
the ends of the protective edge strip and lightly compress them, using a pair of pliers to
secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
CRF1100L Africa Twin Adv. Sports 2020-
Article No..
--- Allen key 3 and 5mm
10635
10992
11038
10673
10641
---
3
Required tools
-