System Parameters - IFM Electronic ecomat200 DL2003 Notice D'utilisation

AL-3
MONITOR

System parameters

Parameter Description, values, default value
MOD Mode (operating mode)
1CH • Single channel
Monitors an analogue signal at input 1 with 2 limit values (outputs 1 and 2).
2CH • Dual channel
Simultaneously monitors two different analogue signals at inputs 1 and 2 with one limit
value each (In1 → output 1; In2 → output 2).
The analogue output reacts to the signal at input 1.
A-B • Comparator (subtraction mode In1-In2)
Forms the difference of 2 analogue signals and monitors the differential value with 2
limit values (outputs 1 and 2). The analogue output reacts to the differential signal.
Au B • Comparator (addition mode In1+In2)
Forms the total of 2 analogue signals and monitors this with 2 limit values (outputs 1
and 2). The analogue output reacts to the signal of the total.
• Values: 1CH, 2CH, A-b, Aub
• Default value: 1CH (single channel)
VER Software Version
The installed software version is displayed (5-digit number with abbreviation VCO)
INx, INP Input (input signal)
4 -20 Selection of the input signal in the 1CH/2CH or A-B/A+B mode
0 -20 • Values: 4-20, 0-20 [mA]
• Default value: 4...20 mA
DHx, DHI Display High (end value of the measuring range)
Corresponds to the actual measuring value at 20 mA
• Values: 1CH/2CH mode: -9999.0...9999.0; A-B/A+B mode: -4999.0...4999.0
• Default value: 20.0
DLx, DLO Display Low (start value of the measuring range)
Corresponds to the actual measuring value at 0 or 4 mA
• Values: 1CH/2CH mode: -9999.0...9999.0; A-B/A+B mode: -4999.0...4999.0
• Default value: 4.0
FOx Function Output (switching function of the outputs)
(1) Relay energises (transistor output conductive) when the current
value is below the switch point. Switches back at SP + HY.
(2) Relay de-energises (transistor output blocked) when the current
value is below the switch point. Switches back at SP + HY.
(3) Relay energises (transistor output conductive) when the current
value is above the switch point. Switches back at SP - HY.
(4) Relay de-energises (transistor output blocked) when the current
value is above the switch point. Switches back at SP - HY.
(5) Relay is energised (transistor output conductive) within a window
(acceptable range).
(6) Relay is de-energised (transistor output blocked) within a window
range.
32
Parameter list see page 41
X
display
principle