Programming; Programming Example Dt2 (Delay Time, Output 2) - IFM Electronic ecomat200 DL2003 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8. Programming

If programming takes place during operation, dangerous contact voltage can
occur. Therefore ensure that programming is done by a qualified electrician.
Parameter changes during operation, especially changes of the switching
function or the teach in of the parameters SP1, SP2, AE3 or AS3 can lead to
malfunction in the plant. In case of doubt stop the plant and change the pa-
rameters manually.
Programming consists of 6 steps:
1. Change from the RUN mode to the parameter range 0...3 pushbutton
2. Selection of the requested parameter (MOD, IN1, etc)
3. Change to the PRG mode
4. Setting or changing the parameter value
5. Acknowledgement of the set parameter value
6. Return to the RUN mode

Programming example DT2 (Delay Time, output 2)

Operation
Change from the RUN mode to the parameter range (here 2)
Briefly press the
-pushbutton three times.
The 2nd parameter range is displayed ...
Selection of the requested parameter (here DT2)
Press the pushbutton
until the parameter DT2 is displayed
with the current set value (here default value 0.0) ...
Change to the PRG mode
Briefly press the pushbutton
The unit is in the programming mode.
PRG indicator visible, parameter abbreviation flashes ...
Setting or changing the parameter value
Press the
or
pushbutton
until the requested parameter value is indicated ...
(also see "Numerical entries" on the following page)
Acknowledgement of the set parameter value
Press the pushbutton
flashes and the indicator PRG has disappeared.
The new parameter value is indicated and effective ...
Return to the RUN mode
Press the
pushbutton for about 3 s or wait for
the Time-Out function (approx. 15 s).
The unit is again in the RUN mode, the current value is indicated ...
once.
until the parameter abbreviation no longer
AL-3
MONITOR
pushbuttons
/
pushbutton
pushbuttons
/
pushbutton
(> 3 s)
pushbutton
(> 3 s)
Display
CH2
RUN
CH2
RUN
CH2
RUNPRG
CH2
RUNPRG
CH2
RUN
35

Publicité

Table des Matières
loading

Table des Matières