Notes On Programming - IFM Electronic ecomat200 DL2003 Notice D'utilisation

AL-3
MONITOR

Notes on programming

RUN mode
During programming the unit internally remains in the RUN mode! (RUN indicator
visible).
This means that until a new value is acknowledged with the pushbutton
unit carries out its monitoring function on the basis of the previously set parame-
ters and switches the relay and transistor outputs accordingly.
Note:
The monitoring function of the monitor is deactivated by continuously pressing the
button in the RUN mode. The deactivation is effective as long as the pushbut-
ton is pressed.
Teach function
SP1 Switch point
SP2 Switch point
AE3 Analogue End Output 3
AS3 Analogue Start Output 3
In addition to the numerical entry the above-mentioned parameters can also be set
by the teach function. In the programming mode this function enables to measure
and display the current input signal and to assign the selected parameter to it.
To teach the actual measured value the same programming steps as for the "nor-
mal" programming are done first.
1. Change from RUN mode to parameter range 1,2 or 3
2. Selection of the requested parameter (SP1, SP2, AE3 or AS3)
3. Change to the PRG mode
(PRG indicator visible, parameter abbreviation flashes)
The teaching is started by pressing the
mode. The current measured value is displayed and can be changed by the
button on request.
As for the numerical programming the value is stored by pressing the
until the parameter abbreviation no longer flashes and the PRG indicator has dis-
appeared.
Time Out Function
If during programming no pushbutton is pressed for approx. 15 s, this is seen as a
cancellation.
Parameter changes which are not acknowledged with the
jected. The previously set parameter value is restored and remains effective for the
monitoring functions.
36
Output 1 (switch point output 1)
Output 2 (switch point output 2)
(end value analogue output)
(start value analogue output)
/ buttons simultaneously in the PRG
the
pushbutton
pushbuttons
pushbutton
or
button
pushbutton are re-
/