Operating And Indicating Elements - IFM Electronic ecomat200 DL2003 Notice D'utilisation

AL-3
MONITOR

3. Operating and indicating elements

1 Display (7/14-segment)
1a Indicators for input channels and operating modes
CH1...CH4
RUN
PRG
TST
KEY
1b Display
1c Display
2 pushbuttons /
3 pushbutton
4 LED In1/2 (yellow)
On:
Slowly flashing:
Quickly flashing:
5 LED Out1/2 (green) Switching state of the output
Off:
On:
Slowly flashing:
Quickly flashing:
6 Interface
7 Panel for labelling
26
Input channels (here: CH1 and CH2)
Run mode (normal operating mode)
Programming mode (setting of the parameter values)
Test mode (only optional)
Status of the unit (locking)
Actual values and parameter values (5-digit, numerical)
• Input signal: 0.0...20.0 mA (max. 23.0 mA)
• Scaled values: -9999 (999.9)...+9999 (999.9)
Outside the valid value ranges the display shows "----".
Parameter abbreviation and units (3-digit, alphanumeric)
Selection of the actual value display, parameter selection,
setting of the parameter values
Selection of the operating mode,
acknowledgement of the parameter value, front reset
Input signals (LEDs active, if In1/2 > 0,1 mA)
Signal in the operating range
Signal in the warning range
Signal in the error range
The output is not switched (relay de-energised, transistor blocked)
The output is switched (relay energised, transistor switched)
The delay time is effective for the output. The output switches when the
delay time has elapsed and the trigger event is still present
(parameter DTx, Delay Time)
The output is kept latched (parameter SOx, Store Output)
(without function)