Information For Operators; Operating Instructions; Setup And Commissioning; Setup - Renfert Vibrax 1830 Mode D'emploi

Tool included.
Observe the Operating Instruc-
tions.
Other symbols are explained as they
occur�
1. Setup and
Commissioning

1.1 Setup

Select a stable base suitable to bear the
weight of the Vibrax� Preferably, the Vibrax
should be set up on a solid, heavy slab�
Please install the unit in order to reach the
mains connection easily�

1.2 Rubber Mat Installation

Before you can begin working with the
Vibrax you must first secure the included
rubber mat on the vibrator table�
During installation, be sure the rubber mat
locks in place under the edges around the
entire circumference of the vibration table
(Figure 6)�
Ensure that the rubber mat locks
into place with its groove below
the edge of the vibration plate
over its entire circumference
(Figure 6).
EN

Operating Instructions

- 2 -

Information for Operators

Using these operating instruc-
tions as a starting point, instruct
all operators of the unit with
regard to the area of application,
the possible hazards during op-
eration, and the proper operation
of the Vibrax.
Please have these operating instructions
readily available for the operators�
Additional information can be found in the
Section,
"Information for Operators",
at the end of these instructions�

1.3 Mains Connection

The device may only be com-
missioned if the information on
the nameplate corresponds to
the specifications of your local
electric power supply utility!
• Move switch (A) to its vertical (OFF)
position (Figure 1)�
• Plug the power cord into the mains
connection (D) (Figure 2)�
• Plug the other end of the power cord
into the mains outlet�
The Vibrax is now ready to use�

2. Operation

2.1 Operating Elements

Refer to Figures 1 and 2�
(A) ON switch and oscillation mode switch
Coarse/Fine
(B) Power level switch
(C) Rubber mat
(D) Mains connection
(E) Device fuse