Installation, Programming And Maintenance; Installation - Zummo Z40 NATURE ONE Manuel D'utilisation

5. INSTALLATION, PROGRAMMING AND MAINTENANCE


It is compulsory for the machine to be earthed to avoid the possibility of people being given
shocks or damage to the equipment.

The plug must be easily accessible once the installation is complete. The use of extension
cables, adaptors and multiple sockets is not permitted.

Machines which does not release with the standard furniture, must be placed on a surface
with a minimum height of 800mm, in the event of installing it on a surface below must be
assembled with the basket cover accessory.

5.1. INSTALLATION


Attention! The machine weighs 81.5 kg. When moving the machine, we suggest that this
should be accomplished by two people. The best way to lift the machine is to grab the rear
of the machine from underneath, with one hand and with the other hand, grab the shaft from
underneath, as well (Fig. 22).

Position the machine on a sufficiently strong, stable and horizontal surface and attach the
machine to the base using M8 screws.

Make sure that the machine's voltage and frequency match the values of your electrical
installation. See the identification plate (Fig. 23).

Use an electrical outlet equipped with an effective ground connection (0.03A). This outlet
should be used exclusively by the juice extraction machine. Do not plug other appliances into
the outlet.

Before operating the machine, wash all machine parts that will be in contact with juice: Balls,
Blade, Juice tray, Filter Tray, Filter and Front Cover.

Turn ON the power switch (Fig. 5 (I=On, O=Off)). If no message appears on the display (Fig.
6), there is lack of power supply. Make sure you have connected the plug to a powered circuit
and that the power switch is switched on. Once this is done, the Programmer display will show
one of the following messages:
31
(Disp. 1)
(Disp. 2)
(Disp. 4a)
(Disp. 5a)
(Disp. 6)
(Disp. 3)
(Disp. 4b)
(Disp. 5b)
(Disp. 7)