Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wire rope winch >LAMBDA< BGV C1 for stages and studios
English
Before taking into operation, please carefully read this operating instruction!
Observe the safety instructions!
File documentation!
Destined use
The wire rope winch >LAMBDA< with spur gear is a manually operated winch for suspension devices in stages
and studios acc. to BGV C1 for lifting and lowering of loads.
Not suitable for use in explosive danger area.
Not suitable for use in corrosive environments.
Power operation is not allowed.
The winch is not designed for continuous operation.
Alterations to the winch or fitting of accessories are only allowed with our written approval.
Pay attention to the technical data and functional description!
Regulations for the Prevention of Accidents
Observe any rules, which are valid for the respective country.
Presently valid in Germany:
EC directive 2006/42/EC
BGV D8 Winches- lifting- and pulling devices
BGV C1 Stages and studios (4.98)
DIN 56950-1:2012-05 – Entertainment technology-Machinery installations
SP 25.1/2 Safety in production facilities
BGR 500 chapter 2.8 Load suspension devices in hoist operation
DIN 15020 page 1 and page 2
FEM 9.661, ISO 4308/1, ISO 4301/1, FEM 9.775, FEM 9.511
1)
in the respective version
Safety Instructions
Operation, installation and maintenance work should only be executed by personnel who are:
Competent, qualified persons
(definition of experts acc. to IEC 364) Qualified persons for reasons of their training, experience and instruction are persons
who do their necessary activities without danger and who can avoid this danger due to their knowledge of directives, regula-
tions for the prevention of accidents and standards. These persons are responsible for the security of the installation.
Acc. to DIN 56950-1 (05.2012), it is necessary, because the changing local, technical and safety
conditions, cannot be sufficient realised, that an instructed qualified person supervised the
operation.
Man riding using the winch to raise, lower, or haul people is strictly forbidden.
Unnecessary loads being moved over people is forbidden (acc. to UVV BGV C1).
Never touch moving parts.
Competent trained personnel must repair defects immediately.
The load
must not be left suspended without supervision,
must not be allowed to swing
must not fall into the wire rope
The rope
should only be rolled in one layer on a grooved drum
should only be used for lifting, lowering or pulling of various loads and must not be used for any
other purpose.
at least 3 full turns of rope should remain on the drum when loaded.
fleet angle (see picture) for standard wire rope 3°, for special rope 1,5°
when filled to its capacity the drum flanges must project not less than 1.5 times the diameter of
the rope.
examine and service regularly acc. to DIN 15020 page 2
only handle with safety gloves
do not touch the rope inlet
technische Änderungen vorbehalten
design changes under reserve
04.04.014
1)
changements techniques sous réserve
3°
3°
1,5°
1,5°
3. 2. 1.
7 / 7
Publicité
Table des Matières
