Operation - Parkside PABSP 20-Li B2 Instructions D'utilisation Et Consignes De Sécurité

˜ Belt clip
(Fig . J)
The belt clip 9 is not assembled upon delivery .
The belt clip can be mounted on either side of a
belt (required tool: Cross tip screwdriver) .
Loosen the belt clip's 9 screw .
¾
Insert the belt clip 9 on either side of the
¾
product . Tighten the screw .
˜ Operation
˜ Attaching/removing the
battery pack
m
CAUTION! RISK OF INJURY!
Always lock the on/off switch 6 to avoid
u
accidental starting by moving the rotation
direction switch 5 into the centre position
(Lock) before attaching/removing the
battery pack 10 .
Removing the battery pack: Press the
¾
battery pack release button 12 . Remove the
battery pack 10 (Fig . D) .
Attaching the battery pack: Align the
¾
battery pack 10 to the handle and slide it
into it . Ensure it clicks noticeably in place .
The battery pack can only be inserted into
the product in one direction .
˜ Checking the battery pack
charging level
(Fig . B)
Check battery pack charge level: Press the
¾
button 13 . The charging level LEDs 14
light up:
LED 14
Red / orange / green
Red / orange
Red
˜ Charging the battery pack
(Fig . C)
¾
¾
¾
¾
¾
Charging level
Maximum
Medium
Low
NOTE
The battery pack 10 may be charged at
u
any time without reducing the life .
Interrupting the charging process does not
u
damage the battery pack 10 .
Charge the battery pack 10 before
operation when it is at medium or low
charging level .
The charging control LEDs (green 17 and
red 18) indicate the status of the charger 15
and the battery pack 10:
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack)
Insert the battery pack 10 into the charger
15 .
Connect the power cord with power plug 16
of the charger 15 to the socket .
When the battery pack 10 is fully charged:
Remove the battery pack from the charger
15 . Then disconnect the power plug 16 of
the charger from the socket .
Status
Battery pack
charges
Battery pack fully
charged
Battery pack
defective
Battery pack too
cold or too warm
Charger ready
GB/IE 33