Instructions For Use; Overheating Safety Device - Sonnenkonig MALA Mode D'emploi

2 Instructions for Use

GB
1. Connect the unit to the power outlet.
2. Turn the knob up to
3. To heat, turn the knob to the
4. For the oscillation function, turn the switch to
5. Please note that the function of the fl ame effect is independent of the heating function.
This means that you can switch on the fl ame effect without switching on the heater.

3 Overheating Safety Device

Your heater is fi tted with a safety device that switches off the heater in case of overheating.
If the heater stops working, turn the heater off, disconnect the plug and check the inlet
and the outlet for any blocking object. Wait for at least 10 minutes before attempting to
restart the heater. If the safety device still switches the heater off and makes the heater
fail to operate, take the heater to your nearest service centre for examination or repair.
start the fl ame effect.
or position.
32
On/off
Flame effect
On/Off
Low
heating level
High
heating level
Oscillation
On/Off
Thermostat
.