Horizon Fitness ADVENTURE 3 Guide D'assemblage page 4

PRE ASSEMBLY
TOOLS REQUIRED:
F T-Wrench (included)
F L-Wrench (included)
UNPACKING
F Screwdriver (not included)
Place the treadmill carton on a level flat surface. It is recommended that you place
a protective covering on your floor. Take CAUTION when handling and transporting
this unit. Never open box when it is on its side. Once the banding straps have been
PARTS INCLUDED:
removed, do not lift or transport this unit unless it is fully assembled and in the upright
F 2 Console Masts folded position, with the lock latch secure. Unpack and assemble the unit where it
will be used. The enclosed treadmill is equipped with high-pressure shocks and may
F 1 Console Assembly
spring open if mishandled. Never grab hold of any portion of the incline frame and
F 1 Hardware Kit
attempt to lift or move the treadmill.
F 1 Safety Key
F 1 Power Cord
F 1 Audio Adapter Cable
• DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
F 1 Bottle of Silicone Lubricant
remove the plastic wrap from console masts.
(for 2 applications)
• FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NEED HELP?
• During each assembly step, ensure that ALL nuts and bolts are in place and
If you have questions or if there partially threaded. It is recommended you complete the full assembly of your
are any missing parts, contact unit before completely tightening any ONE bolt.
Customer Tech Support. Contact
• Several parts have been pre-lubricated to aid in assembly and usage. Please
information is located on the
do not wipe this off. If you have difficulty, a light application of lithium bike
back cover of this manual.
grease is recommended.
6
HZ14_AG_Adventure_3_5_r1_0.indd 6-7
WARNING
IMPORTANT NOTES
ASSEMBLY STEP 1
ADVENTURE 3 SHOWN
1
A
2
HARDWARE FOR STEP 1
PART TYPE QTY
A BOLT 3
A Cut the yellow banding straps and lift the
running deck upward to remove all contents
from underneath the running deck.
B Open HARDWARE FOR STEP 1.
C Attach LEFT CONSOLE MAST (1) to MAIN
FRAME (2) using 3 BOLTS (A).
7/21/14 10:20 AM
7