Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions, p. 2) and connect them to the device.
Select the EMS 29 program, as described in 7.2 "Selecting a program"
(p. 25).
• Using the UP/DOWN buttons, select the desired impulse fre-
quency and confirm with the E button (Fig. 1, Example impulse
frequency of 30 Hz).
• Select the desired treatment time, as described in
7.3.1 "Setting the treatment time" (p. 25).
• Select the desired impulse intensity, as described in
7.2 "Setting the impulse intensity" (p. 25).
Procedure for the EMS 30 program
EMS 30 is a preset program that you can also personalise. In this program, you
can set the impulse frequency to between 1 and 100 Hz. You can also set the
working time and pause time for this program to between 1 and 30 seconds
each.
• Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions, p. 2) and connect them to the device.
Select the EMS 30 program, as described in 7.2 "Selecting a program"
(p. 23).
• Using the UP/DOWN buttons, select the desired length of
working time and confirm with the E button (Fig. 1, Example
working time of 2 seconds).
• Using the UP/DOWN buttons, select the desired length of
pause time and confirm with the E button (Fig. 2, Example
pause time of 10 seconds).
• Using the UP/DOWN buttons, select the desired impulse
frequency and confirm with the E button (Fig. 3, Example
impulse frequency of 30 Hz).
• Select the desired treatment time, as described in
7.3.1 "Setting the treatment time" (p. 25).
• Select the desired impulse intensity, as described in
7.2 "Setting the impulse intensity" (p. 25).
7.4 Changes to the settings
Changing intensity (during application)
+/-
•
und
Interrupting stimulation
Press the ON/OFF button
Changing application (completely or single parameters)
• ON/OFF button
• Setting the program, see 7.2; setting individual parameters, see 7.3.
Fig. 1
7.5 Doctor's Function
Doctor's Function is a specific setting to allow you to call up your specific per-
sonal programme even more easily.
Your individual program settings are instantly recalled and activated when the
device is switched on.
Settings for this individual programme may, for example, be on the advice of
your doctor.
Setting the Doctor's Function
• Select your programme and appropriate settings as described under 7.2 or
7.3.
• At the start of the stimulation treatment, the impulse intensity of
is set to 00 as default. No impulses are sent to the electrodes yet. Be-
fore setting the desired impulse intensity using the intensity setting buttons,
press and hold the
tion is confirmed with a long acoustic signal.
Fig. 1
Cancelling Doctor's Function
To clear the device again and to reallow access to other programs, press and
-
hold the
button again for approx. 5 seconds. To do this, the impulse in-
tensity of
and
confirmed with a long acoustic signal.
8. Cleaning and storage
Fig. 2
Adhesive electrodes
• To ensure that the adhesive electrodes remain adhesive for as long as pos-
sible, clean them carefully with a damp, lint-free cloth or clean the
underside of the electrodes under lukewarm running water and pat dry with a
lint-free cloth.
Fig. 3
27
+/-
: Changing the intensity for each channel.
.
: to interrupt stimulation
-
button for 5 seconds. Storage in the Doctor's Func-
must be set to 00. Deletion of the Doctor's Function is
and
Publicité
Chapitres
Table des Matières
