Accessories; Start-Up - Sanitas SEM 43 Mode D'emploi

Display (full screen):
1 Menu / /
2 Low battery
3 Keylock
4 Timer function (remaining time display) or
working time
5 Frequency display (Hz), pulse width (µs) or
pause time
6 Impulse intensity channel 1 (
7 Impulse intensity channel 2 (
8 Operating status display
9 Program number

Accessories:

• 2x connection cable
• 4x adhesive elec-
trodes (45 x 45 mm)
• 1x belt clip
Key functions
Every time a key is pressed,
this is acknowledged by a signal tone in order to ensure that any unintentional
pressing of a key is detected. This signal tone cannot be switched off.
ON/OFF
(1) Press briefly to switch the device on.
(2) Press once to interrupt stimulation treatment.
(3) Hold ON/OFF key down (approx. 2 seconds) to switch off the machine.
UP and DOWN
Choice of treatment program, treatment time, frequency, pulse width, working
time and pause time.
M (Menu)
(1) Navigation between
(2) Return to program selection screen or menu selection.
E (Enter)
(1) Menu selection.
(2) To confirm a selection made with UP/DOWN, apart from channel intensity.
Intensity setting buttons (
Setting pulse intensity.
1
2
3
4
5
6
)
)
, and menus.
+/- +/-
left, right)
Keylock
Locks the buttons to avoid them being pressed unintentionally.
(1) To activate the keylock, hold down the
visible in the display (approx. 3 seconds).
9
(2) To deactivate the keylock, hold down the
disappears from the display (approx. 3 seconds).
8

5. Start-up

7
1. Remove the belt clip from the machine, if attached.
2. Press the battery compartment cover on the rear of the device
and slide it downwards.
3. Insert three AAA 1.5 V alkaline batteries. Make absolutely
sure that you insert the batteries with the correct polarity as
marked.
4. Replace the battery cover carefully (Fig. 1).
5. Reattach the belt clip, if required.
6. Attach the connecting cable to the electrodes (Fig. 2).
The electrodes have a clip fastener to ensure easy
connection.
7. Guide the connection cable plugs into the socket on the top
of the device (Fig. 3).
8. Do not pull, twist or make any sharp kinks in the cables
(Fig. 4).
Please note that when the battery is replaced or removed,
all settings are restored to the factory default settings.
22
button until the symbol is
button until the symbol
Fig. 1
Fig. 2
Fig. 3
Fig. 4