Assembly And Detachment Of Components According To Model - ZUMEX Speed Manuel De L'utilisateur

Assembly and detachment of
components according to model
1. Assembly
Cover (1)
Line up the 3 holes of the cover with the 3 shaft knobs. Turn these 90º in clockwise direction
(Fig. 10).
Right cover side outlet (2), Left cover side outlet (3), Left cover side outlet S
Make sure that the side outlets are fully mounted and correctly in place (Fig. 10).
The Side Outlets are not the same. Make sure you place the respective Side Outlet on the
correct side.
Line up the lower part of the side outlet and put the upper part into place, turn the knob 90º
to lock it into place.
Lower pressing unit (4), Upper pressing unit (5)
Place the pressing units in the shafts (Fig. 1).
If you have a Speed S +plus then refer to the section 1Step Extraction kit (19+). Always mount
the lower and upper pressing units of the same side at the same time to make it easier to
position them.
Injection Plastic Securing Knob (6)
Screw in the knobs to secure the pressing units and the feeder plate (Fig. 1).
If you have a Speed S +plus then refer to the section 1Step Extraction kit (19+).
Left peel ejector (7), Right peel ejector (8)
Place the ejectors on the respective side on the guides (Fig. 1).
If you have a Speed S +plus then refer to the section 1Step Extraction kit (19+).
Blade holder (9)
Place the blade carefully on its guide and push inwards (Fig. 1).
Blade holder S
Place the blade carefully on its guide and push inwards (Fig. 1+).
Note: Always insert before inserting the 1Step Extraction kit.
Feeder basket (13)
The feeder basket can be removed and re-attached facing guides and making a slight
(3+)
+plus
movement until it stops (Fig. 1).
Feeder basket door (14)
The feeder basket has an easy-to-open door to make it easier to fill the basket up with oranges
(Fig. 1).
Power cable (15)
When you receive the machine, you must connect the cable to the machine base (Fig. 1).
Protector cable with 3 screws (16)
Fit to prevent the cable from being accidentally removed (Fig. 1).
Self Service/Tank Tray gasket 6.3 x 3.5 (17)
If required, this gasket can easily be removed for cleaning and fitted back in by hand (Fig. 1).
Tray bolt (18)
This component only has to be handled if a spare SS Juice container (40) or Tank juice container
(50) is requested (Fig. 1). After inserting the spare container, adjust the bolt from the rear to
adjust the container position.
(9+)
+plus
EN
43