Charging; Maintenance And Cleaning; Troubleshooting - LIVARNO LUX 10609A Instructions D'utilisation Et Consignes De Sécurité

battery compartment. Use only
rechargeable batteries of the
recommended type (see
"Technical data").
Close the battery cover and
tighten the retaining screws
using a small cross-tip screw-
driver.
Push the AUTO / OFF button
to switch the fairy lights on.
Slide the solar cell housing
back onto the cover
Fig. A).

Charging

The battery charging period using
the solar cell depends on the inten-
sity of the sunlight and the angle
incidence of the light on the solar
cell. Place the solar cell as perpen-
dicular as possible to the angle of
light incidence. In this way you will
receive the highest light levels.
Note: The product must be
switched on to charge the battery.
24 GB/IE
The LEDs cannot be replaced. The
solar fairy lights are maintenance
free except for replacing the battery.
7
2
1
(see
5
Note: The device contains sensitive
electronic components. Radio trans-
mitting equipment in the immediate
vicinity may therefore cause inter-
ference. If you notice the device is
malfunctioning, remove any sources
of interference from the area around
the device.
Note: Electrostatic discharge can
lead to malfunctions. In the event of
such malfunctions, briefly remove and
reinsert the rechargeable batteries.
Maintenance
and cleaning
Regularly clean the solar fairy
lights with a dry, lint-free cloth.
Use a slightly moist cloth to
remove any stubborn dirt.

Troubleshooting