Operating Instructions; Setting The Clock; Kitchen Timer; Microwave Function - ETNA ECM280ZT Mode D'emploi

OPERATING INSTRUCTIONS

Setting the clock

Kitchen timer

Microwave function

When the appliance is connected to the network for the first time,
you need to set the time. The display reads '00:00'. The clock runs
as long as the combi-microwave is connected to the network. First
press any key to wake up the microwave from the standby
mode.
1. Press the clock button.
The hours flash in the display.
2. Turn the control dial to set the hours.
The set hours appear in the display.
3. Press the clock button again.
The minutes flash in the display.
Turn the control dial to set the minutes.
The set minutes appear in the display.
4. Press the clock button again.
The clock is set: the current time appears in the display with a
flashing ':'.
The kitchen timer gives a signal after reaching the set time.
1. Press the clock button twice.
The display reads '0:00'.
2. Turn the control dial to set the time.
The display indicates the set time (max. 95 minutes).
3. Press the start button.
The set time counts down in the display.
• When the set time has been reached, the current time
appears again in the display, and you will hear 5 beeps.
• You cannot adjust the set time during countdown. Press on
the stop button to interrupt the kitchen timer and set a new
time.
With this function you can set the power and time yourself. If you
don't set the power, the microwave will switch on at the highest
power. In the following table you can see which power levels can
be set.
EN 9