Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.3.2
Front face (including HF protection fabric)
Replacement kit and tools
KR KARAGR or KR TISSU, electric screwdriver with torque selector (N.m or in.lb
LOCKBLUE.
Front face removal procedure
1.
Put the enclosure with rear side on the workbench and logo on the right.
2.
Remove a fin on one side by removing both hex screws (5 mm hex bit).
Remove the corresponding grill by removing the 4 Torx
3.
4.
Repeat steps 2 and 3 for the fin and grill on the other side.
5.
Remove the HF protection fabric (with both joints) from the center of the front face.
Front face mounting procedure
1.
Stick two foam joints around both large sides of the new fabric.
2.
Put the fabric on the enclosure (fittings on the enclosure side).
3.
Mount a grill (grill with logo on the right) with BLP holes oriented outwards and screw in four Torx
bit, thread-locker, 3 N.m/27 in.lb
4.
Mount a fin and screw in two hex screws (5 mm hex bit, thread-locker, 3 N.m/27 in.lb
5.
Repeat steps 3 to 4 for the other side of the front face.
8.3.3
Protective elements
Replacement kit and tools
KR KARAPR, electric screwdriver with torque selector (N.m or in.lb
KR LOCKBLUE.
Front protective elements removal procedure
1.
Put the enclosure horizontally with left or right side facing the user.
2.
Remove the front protective element by removing both hex screws (5 mm hex bit).
3.
Repeat the procedure for the other front protective element.
Front protective elements mounting procedure
1.
Insert two hex screws into a front protective element and then insert both BLP sling ends into them (arrange both
slings as shown in Figure 15).
2.
Install the protective element on the enclosure side and screw in both hex screws (5 mm hex bit, thread-locker, 3
N.m/27 in.lb
).
f
3.
Repeat the procedure for the other front protective element.
Rear protective elements removal procedure
1.
Put the enclosure horizontally with rear side facing the user.
2.
Remove both bolts from a rear protective element and the corresponding rigging element (5 mm hex bit, 13 mm
hex socket).
3.
Remove both hex screws from the rear side of the enclosure.
4.
Remove the rear protective element. Put the upper rigging spacer and steel bar in a safe place as these are not
included in the replacement kit.
5.
Repeat the procedure for the other rear protective element.
KARA_UM_ML_1-3
®
screws (T30 bit).
).
f
w w w . l - a c o u s t i c s . c o m
), 5 mm hex bit, T30 Torx
f
).
f
), 5 mm hex bit, 13 mm hex socket key,
f
®
bit, KR
EN
®
screws (T30
21 en
21
21
21
Publicité
Chapitres
Table des Matières
