L-Acoustics KARA Manuel D'utilisation page 18

® ® ® ®
KARA KARA KARA KARA
M M M M O O O O DULAR DULAR WST DULAR DULAR
user manual user manual user manual user manual
VERSION 1.3
4 - When combining [KARA] with [SB28_60] the KARA is associated with the SB28 in decoupled configurations
only. The SB28:KARA recommended ratio is 1:2.
Note1: A small KARA array (typically composed of 6 enclosures as shown in Figure 12) of standard curvature provides
a flat contour. If needed, the KARA contour can be reinforced in the low frequency domain using the LF CONTOUR
tool of LA NETWORK MANAGER Software [3.4] with frequency set at 180 Hz and gain set between 0 and 4 dB.
The association of KARA and LF CONTOUR allows reaching some unprecedented results when KARA are flown and
SB28 are stacked due to the extended bandwidth and low-end capabilities of KARA.
Note2: This configuration is possible but not optimized. Due to the lower sensitivity and additional LF extension of
SB28 versus SB18, it requires a SB28:KARA ratio of 1:2 (a third more 18" drivers are needed).
Figure 12: KARA/SB28 combination examples in LOW EXTENSION mode (part 2)
KARA_UM_ML_1-3
® ® ® ®
WST WST WST LINE SOURCE LINE SOURCE LINE SOURCE LINE SOURCE
w w w . l - a c o u s t i c s . c o m
[KARA]
[SB28_60]
16 en 16 16 16