® ® ® ®
KARA
KARA
KARA
KARA
M M M M O O O O DULAR
DULAR WST
DULAR
DULAR
user manual
user manual
user manual
user manual
VERSION 1.3
7.4.2
Connecting KARA to LA8
The first two KARA enclosures are connected to the output channel pairs 1/2 and 3/4 of the LA8 controller. Two
additional KARA enclosures can be connected in parallel with each first one. Therefore a single LA8 amplified controller
can drive up to six KARA enclosures (see Figure 14).
Figure 14: Six KARA enclosures connected to an LA8 controller
7.4.3
[KARA] preset
The [KARA] preset features a dedicated system contour for mid and long throw applications within the 55 Hz-20 kHz
frequency range allowing it to be used along with the SB18 and/or SB28 presets.
Note: The same [KARA] preset is used in both FULL RANGE and LOW EXTENSION modes.
Depending on the chosen configuration, delays may have to be added in the presets. Refer to the LA4-8
PRESET LIBRARIES User manual included in the LA8 PRESET LIBRARY Pack [3.4] to obtain the
delay values.
IMPORTANT
Activate the LOAD PRESET menu from the LA8 amplified controller front panel and then select the [KARA] preset.
Refer to the LA8 User manual [3.4] for additional instructions. The preset is also accessible using LA NETWORK
MANAGER Software [3.4]. The accessible parameters in LOW EXTENSION mode are shown in the following chart:
Table 5: Accessible parameters in LOW EXTENSION mode
LA8 Inputs/
Outputs
IN A
IN B
OUT 1
KARA enclosure
OUT 2
OUT 3
KARA enclosure
OUT 4
* IN: input signal.
A, B: channel A, B.
KARA_UM_ML_1-3
® ® ® ®
WST
WST
WST
LINE SOURCE
LINE SOURCE
LINE SOURCE
LINE SOURCE
OUT 1/2 (IN A)
OUT 3/4 (IN A)
Elements
Preset
to connect
assignments*
Input signal A
IN_A
Input signal B
IN_B
LF_A
HF_A
LF_A
HF_A
LF: low frequency transducer.
w w w . l - a c o u s t i c s . c o m
Accessible (O) and blocked (X) parameters
Mute
Gain
X
O
X
O
O
X
O
X
O
X
O
X
HF: high frequency transducer.
IN A
Delay
Polarity
O
O
O
O
X
X
X
X
X
X
X
X
18 en
18
18
18