L-Acoustics KARA Manuel D'utilisation page 7

4 4 4 4 KARA KARA S S S S YSTEM YSTEM
KARA KARA YSTEM YSTEM
®
®
The L-ACOUSTICS KARA
operates over the 55 Hz to 20 kHz nominal frequency bandwidth. This response can be extended down to 32 or 25 Hz
with the addition of the L-ACOUSTICS
The system approach developed by L-ACOUSTICS
of the possible configurations and optimize the system. The main components of the system are (see also Figure 1 and
Figure 2):
®
KARA
M-BUMP
M-BAR
M-JACK
KARA-ANGARMEX
KARA-PULLBACK
KARA-MINIBU
KARA-MINIBUEX
SB18
SB28
LA8
LA NETWORK MANAGER
SOUNDVISION
®
The KARA system components are compatible with standard L-ACOUSTICS
®
the L-ACOUSTICS DOFILL-LA8 Loudspeaker cable allowing connection of the KARA enclosure to the LA8
amplified controller. This cable features 8-point PA-COM
using one of the L-ACOUSTICS
Each DO cable is an 8-conductor cable with 4 mm
®
PA-COM connectors. Note: The PA-COM
®
The L-ACOUSTICS SP.7, SP10, and SP25 Loudspeaker cables with respective lengths of 0.7 m/2.3 ft,
10 m/32.8 ft, and 25 m/82 ft will allow connecting KARA to KARA and can also be used to connect KARA to LA8. Each
cable is 4-conductor cable with 4 mm
connectors.
The KARA system is exclusively driven and powered by the L-ACOUSTICS
ensures intelligent protection, filtering, and equalization of the enclosures. Four channels of amplification are provided
along with the factory LA8 PRESET LIBRARY [3.4], ensuring the optimization and performance of the system within
limitations of the recommended configurations.
Each system design configuration should first be modeled and studied using L-ACOUSTICS
Software [3.4]. Software predictions are based on the preset parameters stored in the amplified controllers.
Up to 253 amplified controllers can be interconnected and monitored through the proprietary L-ACOUSTICS
L-NET Network using LA NETWORK MANAGER Software [3.4].
KARA_UM_ML_1-3
®
enclosure belongs to the KARA
®
SB18 or SB28 subwoofer, respectively.
®
for KARA consists of the elements needed to fully take advantage
Full range active 2-way modular WST
Structure for flying or stacking a vertical KARA and/or SB18 array
Extension bar for M-BUMP
Stacking bases (x4) for KARA and/or SB18 arrays
(including 2 angle arm extensions)
Angle arm extensions (x2) for stacked KARA and/or SB18 arrays
Rigging accessory for KARA array pullback configuration
Structure for flying or stacking a small format KARA and/or SB18 array
KARA-MINIBU extension accessories for SB18 rigging
Compact high power subwoofer
High power subwoofer
Amplified controller
Remote control software for amplified controllers
Acoustical and mechanical modeling software
®
®
DO10 or DO25 Cables with respective lengths of 10 m/32.8 ft and 25 m/82 ft.
2
conductor cross-section (13 SWG, 11 AWG) and features 8-point
®
standard is fully compatible with the CA-COM
2
conductor cross-section (13 SWG, 11 AWG) and features 4-point SpeakON
w w w . l - a c o u s t i c s . c o m
®
Modular WST
®
®
accessories. These accessories include
®
and 4-point SpeakON connectors and must be extended
®
LA8 Amplified controller [3.4]. This
®
Line Source System and
enclosure
®
standard.
®
SOUNDVISION
5 5 5 5 en
EN
®
®