Snapper Beal Notice D'emploi page 21

Cleaning the Battery and Cables
WARNING
When removing or installing battery cables,
disconnect the negative cable FIRST and reconnect
it LAST. If not done in this order, the positive terminal
can be shorted to the frame by a tool.
1. Disconnect the cables from the battery, negative cables
first (A, Figure 7) then the cover and positive cables (B).
2. Loosen the wingnut and washer (D).
3. Pivot the hold-down rod (C) up and away from battery.
Secure to steering tower.
4. Remove the battery (E).
5. Clean the battery compartment with a solution of baking
soda and water.
6. Clean the battery terminals and cable ends with a wire
brush and battery terminal cleaner until shiny.
7. Reinstall the battery (E) in the battery compartment.
Secure with the battery hold-down rod (C) and wingnut &
washer (D).
8. Re-attach the battery cables, positive cables and cover
first (B) then the negative cables (A).
9. Coat the cable ends and battery terminals with petroleum
jelly or non-conducting grease.
Battery Charging
WARNING
Keep open flames and sparks away from the
battery; the gasses coming from it are highly
explosive. Ventilate the battery well during
charging.
A dead battery or one too weak to start the engine may
be the result of a defect in the charging system or other
electrical component. If there is any doubt about the cause
of the problem, see your dealer. If you need to replace the
battery, follow the steps under Cleaning the Battery and
Cables.
To charge the battery, follow the instructions provided by
the battery charger manufacturer as well as all warnings
included in the safety rules sections of this book. Charge
the battery until fully charged. Do not charge at a rate higher
than 10 amps.
en
Seat Adjustment
Pitch Adjustment
The pitch of the seat can be adjusted to one of three
positions. To adjust, remove the carriage bolts, spacers,
washers, and nuts (B, Figure 8) from the hinge and reinstall
them in the desired holes.
Seat Slide Adjustment
The seat can also be adjusted forward and back. Move the
lever (A, Figure 8), position the seat as desired, and release
the lever to lock the seat into position.
Seat Spring Adjustment
The seat springs (C, Figure 8) can be adjusted to provide a
softer or firmer ride. Tilt the seat forward and slide the spring
assembly (C) forward for a softer ride, and back for a firmer
ride.
Manual Lift Assist Adjustment
If the manual lift does not function properly, see your dealer.
Mower Gauge Wheels
The mower gauge wheels can be placed in several positions
depending on the height of cut. When using higher cutting
heights, set the wheels in the lower position. When using
lower cutting heights, set the wheels in the upper position.
1. Remove the locknut (A, Figure 9), gauge wheel (B),
washer (C), and shoulder bolt (D). Change position of
gauge wheel to desired height.
2. Insert shoulder bolt (D) through washer (C) gauge wheel
(B), and gauge wheel bracket (E). Secure with locknut
(A). Repeat Steps 1 & 2 for all gauge wheels.
Maintenance
21