Starting; Turning Off The Engine - Solo 128L Instructions D'emploi

If the engine is running in part throttle operation:,
briefly pull the throttle back to release the half
throttle detent. Release the throttle lever again to
allow the engine to run at idle speed. Now you can
commence working.

7.3 Starting

Observe the safety instructions when starting.
Lay the brushcutter level and without obstructions on
the ground.
During starting, never stand or kneel on the shaft
tube, otherwise the shaft or the tube might be
damaged.
Take up a safe position, securely hold the machine
and ensure that the cutter does not touch any objects
or the ground.
Move the stop switch to the operating position.
The following instructions are aimed at increasing the
service life of the starter rope and of the starter
mechanism:
 Always pull the rope out in a straight line.
 Do not let the rope drag across the edge of the
rope eyelet.
 Do not pull rope all the way out - risk of the rope
breaking.
 Always manually guide the rope back into its start
position with your hand on the starter grip - do not
let it retract on its own.
A specialist can replace a damaged starter rope.
We recommend the following procedure if the engine
is flooded and it is difficult to start the engine:
 Remove the spark plug and dry fuel mixture from
the electrodes.
 Move the throttle lever up to full throttle. Pull the
starter handle several times (with removed spark
plug) to clear the combustion chamber.
 Move the throttle lever down to idling position, refit
the spark plug, the plug cap and the plug cover.

7.4 Turning off the engine:

Release the throttle and push the stop switch to
"STOP".
Important: Due to the centrifugal clutch, the cutter
will run on for a short time, even if you release the
throttle. Ensure the cutter has come to a full standstill
before storing the machine.
Fig. 13
Starting / Stopping the engine
ENGLISH 15